|Fixing the Wall Cutting Guide to the existing structure and using the edge to follow with your saw, allows you to control your cut. The blade follows the Guide as it forms the cut, rather than tracking in the direction of a free hand cut. This keeps everything straight, accurate and in the position you need it.
The Wall Cutting Guide is simple to fix to the structure you are cutting. Drill two 15mm diameter holes 30mm deep on the waste side of the cut, push the lugs into the holes, level the guide and tighten. Untighten the lugs and slide the Guide up or down to increase the length of cut without having to re-drill.
Cut up to 2.1m in length and make two parallel cuts 100mm (4”) apart without the need to remove and re-position the Guide.
Also see our other products...